Rosewill RNX-N400LX - Manual (Page 29)

Wireless Router RNX-N400LX User Manual
2.4GHz(B+G+N)
Mode
Click to select:
AP
Client
WDS
AP+WDS wireless mode. (WDS Security Setting in 3.8)
** Please note change mode will result in around 1~3 minutes delay of
internet connection due to system reboot and internet re-connects.
Network Type
While Mode is selected to be Client. Click to select the network type
infrastructure or Ad hoc.
SSID It is the wireless network name. The SSID can be 32 bytes long.
Channel Width
Select the operating channel width 20 MHz or 40 MHz.
[N band only]
Control
Sideband
Select the Sideband with Upper or Lower for channel
width 40MHz.
[N band only]
Channel Number Select the wireless communication channel from pull down menu.
Broadcast SSID Click to enable or disable the SSID broadcast function.
WMM Click Enabled/Disabled to enable WMM feature.
Data Rate
Select the transmission data rate from pull-down menu.
Data rate can be auto-select, 1M to 54Mbps or MCS.
Associated
Clients
Click the Show Active Clients button to open Active Wireless Client
Table that shows the MAC address, transmit-packet, receive-packet
and transmission-rate for each associated wireless client.
Enable Mac
Clone (Single
Ethernet Client)
Take Laptop NIC MAC address as wireless client
MAC address. [Client Mode only]
SSID of
Extended
Click to enable Universal Repeater Mode
Interface Assign SSID when enables Universal Repeater Mode.
Apply Changes
Click the Apply Changes button to complete the new configuration
setting.
Reset
Click the Reset button to abort change and recover the previous
configuration setting.
3.32 Wireless – Advanced Setting
These settings are for technically advanced users who have a sufficient knowledge about
wireless LAN. These settings should not be changed unless you know what effect the
changes will have on your RNX-N400LX.
29