Regency P33R-LP2 - Manual (Page 24)

Regency P33R-2 Zero Clearance Rear Vent Direct Vent Gas Fireplace 24
OPTIONAL BAY DOOR
The Bay louvers MUST be used
with the Bay glass option.
The optional Bay door is an overlay on the
flush front. The standard flush door and glass
must remain on the unit.
1) Hook the top of the bay door over the flush
door flange and swing the bottom against
the bottom flange of the flush door.
2) Secure to the flush door bottom bracket with
2 screws provided.
3) Slide the valve extension knobs onto the
valve knobs.
INSTALLATION
Diagram 1 Diagram 2
FLUSH LOUVERS
1) Install the top louver by sliding the two
bracket clips into the brackets located un-
derneath the top of the firebox.
2) Install the bottom louver by folding the lou-
ver down and then sliding the Bottom Lou-
ver bracket down onto the 2 pins on the
base of the unit (dia. 1). Secure with 1
screw as per dia. 2.
Note: Top and
bottom louvers
are different.
3) Open the bottom louver. Pull the Burner ON/
OFF control box from inside the bottom of
the fireplace and position the slots in the
bracket over the 2 screws on the left side
of the bottom louver. Push down to lock into
place. Tighten the screws.
Screws on
louver bracket
Burner ON/OFF control box attached to
bottom flush louver.
Burner ON/OFF
control box
Note: If any maintenance etc. must be
done in the firebox, first remove
the Bay louvers and door.
Optional Bay Trim
Attach 4 supplied magnets each to the back of
the top and bottom trim pieces, and attach trim
to the top and bottom of Bay door.
DOUBLE SCREEN
DOOR
1) Pull out the top louver.
2) Center the screen door and hook over the
flush door.
3) Open the screen door(s) and secure the
screen door to the flush door front with 2
clips on the bottom left and right side.
Clip locations
Clip installed on right side.