Maintenance, Thermopile/ thermocouple, Glass gasket – Regency P33R-LP2 User Manual

Page 31: Door glass

Advertising
background image

Regency P33R-2 Zero Clearance Rear Vent Direct Vent Gas Fireplace

31

MAINTENANCE

THERMOPILE/

THERMOCOUPLE

1) Open the bottom louvers.

2) Loosen the thermocouple or thermopile with

a 7/16" wrench.

3) Disconnect thermocouple by loosening nut

from the valve with a 9mm wrench. Discon-
nect thermopile by loosening 2 screws
marked TP on the valve.

4) Drop the thermocouple or thermopile down

from the bracket and pull it out of the unit.

5) Reinstall the new ones in reverse order.

GLASS GASKET

If the glass gasket requires replacement use
5/8" flat glass gasket for the Bay Front (Part #
936-243) and a tadpole glass gasket for the
Flush Front (Part # 936-155).

DOOR GLASS

Your Regency stove is supplied with high
temperature, 5 mm Neoceram ceramic glass
that will withstand the highest heat that your
unit will produce. If your glass requires
cleaning, we recommend using an approved
glass cleaner available at all authorized deal-
ers. Do not use abrasive materials. Do not clean
the glass when hot.

In the event that you break your glass by impact,
purchase your replacement from an authorized
Regency dealer only, and follow our step-by-
step instructions for replacement.

Flush Glass Replacement

Remove the flush door front (as per instructions
on page 23). Remove the 4 glass clips from each
corner. Slide in the new replacement glass.
Push the 4 glass clips back onto the frame. The
glass must have gasketing around it.

Bay Glass Replacement

1) Remove the door from the unit and place on

a soft surface to prevent scratching.

2) Remove the nuts holding the glass clips in

place and remove.

3) Replace the glass. The glass must have

gasketing around it.

5) Reverse the previous steps, replace the

glass clips and fasten with the nuts but do
not over tighten, as this can break the glass.

6) Replace door on the stove and check the

seal.

WARNING: Do not operate the
appliance with the glass panels
removed, cracked or broken. Re-
placement of the glass panels
should be done by a licensed or
qualified service person.

Caution: Wear gloves when remov-
ing damaged or broken glass.

Advertising
This manual is related to the following products: