Regency Sunrise Gas Fireplace L676S-NG1 - Manual (Page 18)

Regency® L676S Direct Vent Gas Fireplace 18
INST
ALLA
TION
INSTALLATION
RIGID PIPE VENTING SYSTEMS
BASIC HORIZONTAL & VERTICAL TERMINATIONS
Rigid Pipe Vent Systems offer a complete line
of component parts for installation of both
horizontal and vertical installations. Many
items are offered in decorative black, as well
as galvanized fi nish.
The minimum components required for a basic
horizontal termination are:
1 AstroCap XL
1 90 o Elbow
1 Rigid Pipe Adaptor
1 Wall
Thimble
1 Length of pipe to suit wall thickness
The minimum components required for a basic
vertical termination are:
1 Vertical Termination Cap
1 Rigid Pipe Adaptor
1 Lengths of pipe to adequately
penetrate
roof
1 Ceiling Firestop
1 Flashing
1 Storm
Collar
Wall thickness is measured from the back
standoffs to the inside mounting surface of
termination cap. For siding other than vinyl furring
strips may be used, instead of the vinyl siding
standoff, to create a level surface to mount the
vent terminal. The Terminal must not be recessed
into siding. Measure the wall thickness including
furring strips.
If a Vinyl Siding Standoff is required (it must
be used with vinyl siding), measure to outside
surface of wall without siding and add 2
inches.
Alternate
Horizontal Termination
Caps
Rigid Pipe
Adapter
(770-994)
Pipe Length
Vertical Terminal
Storm Collar
Flashing
Ceiling Firestop
Pipe
Length
Pipe Length
90 Elbow o
AstroCap XL
Termination Cap
(Part #946-623/P)
Wall Thimble
(Mandatory in all
Horizontal Terminations)
Vinyl Siding
Standoff (Optional)
Vent Guard - if required*
(Part #946-506/P)
When using Rigid Vent other than
Simpson Dura-Vent, 3 screws must be
used to secure rigid pipe to adaptor.
The FPI AstroCap XL TM is certifi ed for installations using FPI venting systems as well as Simpson Dura-Vent ® Direct Vent Pro and Selkirk Direct-Temp.
AstroCap XL TM is a proprietary trademark of FPI Fireplace Products International Ltd. Dura-Vent® and Direct Vent are registered and/or proprietary trade-
marks of Simpson Dura-Vent Co. Inc.
This product has been evaluated by Intertek
for using a Rigid Pipe Adaptor in conjunction
with Simpson DV Pro, Metal-Fab Sure-Seal
and Selkirk Direct-Temp systems. Use of these
systems with the Rigid Pipe adaptor is deemed
acceptable and does not affect the Intertek WHI
listing of components.
WARNING:
Do not combine venting components from
different venting systems.
Exception: However, use of the AstroCap XL TM
is acceptable with all systems.
Part # 5DT-ST14 (14")
Part # 5DT-ST36 (36")