Ricoh Aficio FX200 - Manual (Page 231)

T ROUBLESHOOTING 9.28
Solving Network Printing Problems
General Problems
Condition Suggested solutions
System does not function
with some wrong values
entered by mistake while
configuring.
Possibly the parameters in the network card are
corrupted. Restart the system and set to factory
defaults. See “Restoring the Network Configuration” on
page A.8.
Not able to access from
SNMP Manager.
Try pinging from the same system on which SNMP
manager is running. If it does not succeed, there must
be a problem with network connectivity between the
manager and the machine. If ping succeeds, verify that
community names with sufficient permissions have been
used.
You cannot see any of
DHCP server, BOOTP
server or RARP server,
when you want to set IP
address to the machine.
You should set IP address, Subnet Mask and Default
Gateway to the machine using Set IP.
You can not print using
TCP/IP protocol.
1.Check whether TCP/IP protocol is installed in your PC.
2.Check whether your PC is on the same network with
the machine.
The name of printer is
displayed empty while
adding a port and the
printer doesn’t function.
Assign IP Address by using the Set IP.