Ricoh Aficio FX200 - Manual (Page 252)

A
U SING Y OUR M ACHINE ON A N ETWORK A.7
An IP address consists of 4 bytes.
7 Press the scroll button ( or ) to enter a number between
0 and 255 and press Enter or Upper Level to move
between bytes. Enter a number using the number keypad
and use the scroll button ( or ) to move between bytes.
8 Repeat step 7 to complete the address from the 1st byte to
the 4th byte.
9 Press Enter.
10 To select other parameters, such as a Subnet Mask or a
Gateway, press the scroll button ( or ) until the desired
item displays on the bottom line. Press Enter.
11 Repeat steps 7 through 9 to configure the other TCP/IP
parameters.
12 Press Clear/Stop to return to Standby mode.
Dynamic Addressing (BOOTP/DHCP)
To have the TCP/IP address assigned automatically by the
server, take the following steps:
1 Press Menu until you see “Network Setup” on the top line
of the display.
2 Press the scroll button ( or ) until “Config Network”
appears on the bottom line.
3 Press Enter.
The first available menu item, “TCP/IP,” appears on the
bottom line.
4 Press the scroll button ( or ) to display “DHCP” on the
bottom line and press Enter.
5 To assign the address from the BOOTP server, press Enter
when “BOOTP” displays on the bottom line.
Enter a number between 0
and 255 for each byte.