Ricoh Aficio FX200 - Manual (Page 250)

A
U SING Y OUR M ACHINE ON A N ETWORK A.5
• DHCP: Dynamic Host Configuration Protocol
• BOOTP: Bootstrap Protocol
Printing a Network Configuration Page
The Network Configuration page shows how the network
interface card on your machine is configured. The default
settings which are suitable for most applications are enabled.
1 Press Menu until you see “Network Setup” on the top line
of the display.
2 Press the scroll button ( or ) until “Print Net CFG”
displays on the bottom line.
3 Press Enter.
The first available menu item, “Yes,” displays on the bottom
line.
4 Press Enter.
The Network Configuration page (NETWOR PRINTER CARD
TEST PAGE) prints out.
Setting Network Protocols
When you first install the machine, all supported network
protocols are enabled when you turn the machine on. If a
network protocol is enabled, the machine may actively transmit
on the network even when the protocol is not in use. This may
increase network traffic slightly. To eliminate unnecessary
traffic, you can disable unused protocols.
1 Press Menu until you see “Network Setup” on the top line
of the display.
2 Press the scroll button ( or ) until “Config Network”
displays on the bottom line.
3 Press Enter to access the menu.
4 Press the scroll button ( or ) until you see the desired
protocol on the bottom line.
5 Press Enter.
If you selected “TCP/IP,” assign a TCP/IP address. For
details, see page A.6.