Turning off the power, Connecting a microphone, Using headphones – Roland AT20s User Manual

Page 17

Advertising
background image

17

Before You Start Playing

Turning Off the Power

1.

Before switching the power off, set the [Master

Volume] knob to the Min (minimum) position.

2.

Press the [Power On] switch to turn off the

power.

fig.01-06

Connecting a Microphone

You can connect a microphone into the Mic In jack, and enjoy

karaoke with the AT-20S.

fig.01-08

1.

Connect a microphone (sold separately) to the

Mic In jack on the lower-right area of the instru-

ment.

2.

Rotate the [Mic Echo] knob in front of the Mic In

jack to adjust the echo level.

3.

Rotate the [Mic Volume] knob in front of the

[Mic Echo] knob to adjust the volume level for

the microphone.

Some Notes on Using a Microphone

• Be careful of high volume levels when using mikes late at

night or early in the morning.

• When connecting a microphone to the AT-20S, be sure to

lower the volume. If the volume control is too high when

the microphone is plugged in, noise may be produced by

the speakers.

• Howling could be produced depending on the location of

microphones relative to speakers. This can be remedied

by:

• Changing the orientation of the microphone.

• Relocating microphone at a greater distance from

speakers.

• Lowering volume levels.

Using Headphones

The AT-20S features a Phones jack. This allows you to play

without having to worry about bothering others around you,

even at night.

fig.01-08

1.

Connect the headphones to the Phones jack on

the underside of the unit.

The sound from the built-in speakers stops.
Now, sound is heard only through the headphones.

2.

Adjust the headphones volume with the [Master

Volume] slider and Expression pedal.

* Accepts connection of Stereo headphones.

Some Notes on Using Headphones

• To prevent damage to the cord, handle the headphones

only by the headset or the plug.

• Headphones may be damaged if the volume is too high

when they are plugged in.

Lower the volume on the AT-20S before plugging in

headphones.

• To prevent possible auditory damage, loss of hearing, or

damage to the headphones, the headphones should not be

used at an excessively high volume.

Use the headphones at a moderate volume level.

Power On

OFF

Upper position

Mic In Jack

Mic Echo knob

Volume knob

AT-20S.e.book 17 ページ 2003年11月10日 月曜日 午後2時37分

Advertising