Roland AT20s - Manual (Page 55)

55
Using the Registration Buttons
❍ If you wish to save the data without erasing the Registration set
already on disk
1.
Press the [Reset] button to cancel the procedure.
Rewriting of the Registration will be canceled.
2.
Press the Select [-] [+] buttons to select a number for which “- - -” is
displayed on the upper right of the screen.
3.
Press the [Save] button to save the Registration set.
When the data has been saved, the basic display reappears.
When the Registration set is saved to the floppy disk, the indication of “- - -” will change
to “USE.”
Loading Previously Saved Registration Sets Into
the AT-20S
Here’s how to recall a previously saved Registration set from the floppy disk into the
memory of the AT-20S.
Registrations can be selected in the following two ways.
• Loading a Set of Registrations
You can load a “set” (a collection of settings for Registration buttons [1]–[4]) from floppy
disk.
• Loading an Individual Registration
You can load settings for an individual Registration button [1]–[4].
Be aware that when you load Registrations from a disk, the Registrations that were previously
in internal memory will be lost. It is a good idea to save important Registrations to floppy disk
(see p. 54).
■ Loading a Set of Registrations
Registrations Sets saved to a floppy disk can be loaded back into the instrument.
1.
Insert the floppy disk into the disk drive.
2.
Press the [Registration] button (indicator lights).
3.
Press the Select [-] and [+] buttons to select the Registration set
that you wish to load.
fig.07-13
To cancel the procedure, press the [Registration] button.
4.
Press the [Load] button to execute loading.
When loading is complete, the basic screen reappears.
NOTE
AT-20S.e.book 55 ページ ２００３年１１月１０日 月曜日 午後２時３７分