Roland AT20s User Manual
Page 39
39
Using the Rhythm Performance
6.
Press the Rhythm [Disk] button to confirm the storage-destination
Rhythm.
fig.03-17
To cancel the procedure, press the [Display/Exit] button.
7.
Press the Rhythm [Disk] button again to start loading the Rhythm
into the internal memory.
While the Rhythm is being loaded into internal memory, the following screen will be dis-
played.
fig.03-18
Once the Rhythm has been accommodated in memory, the basic screen reappears.
Never remove the disk or turn off the power while the Rhythm data is being
loaded from disk into the AT-20S. If you do so, the Rhythm data will not be
loaded into the AT-20S, and malfunctions could result. After returning the
Rhythm stored in the Rhythm [Disk] button to the factory settings (see following
section), re-load the Rhythm from disk.
■
Restoring the Rhythm Stored in the Rhythm [Disk] Button to the
Factory Settings
The Rhythm that was loaded from the Music Style disk into the Rhythm [Disk] button
will not disappear even if you turn off the power or execute the Factory Reset operation.
If you wish to restore the Rhythm of the Rhythm [Disk] button to the factory setting, use
the following procedure.
1.
Press the [Power On] button to turn off the power (p. 17).
2.
Hold down the Rhythm [Disk] button, and press the [Power On]
switch.
The Rhythm that had been stored in the Rhythm [Disk] button will return to the factory
settings.
To return settings other than those of the Rhythm [Disk] button to the factory settings, use the
Factory Reset operation (p. 18).
NOTE
AT-20S.e.book 39 ページ ２００３年１１月１０日 月曜日 午後２時３７分