Roland AT20s - Manual (Page 80)

80
Settings for the Composer
Adjusting the Metronome
Volume
You can adjust the volume of the metronome.
1. Press the [Function] button.
2. Using the Select [-] and [+] buttons, select “Met-
ronome Vol.”
fig.09-03
3. Press the [Bwd]/[Fwd] buttons to select the
desired volume level (1–10).
Increasing the value will raise the volume of the metro-
nome.
To return to the basic screen, press the [Function] button
or the [Display/Exit] button.
Changing the Sound of the
Metronome
You can choose one of 4 different sounds for the metronome.
1. Press the [Function] button.
2. Press the Select [-] and [+] buttons to select
“Metronome Sound.”
fig.09-04
3. Press the [Bwd] / [Fwd] buttons to select the
type of sound for the metronome.
CLICK&BELL Conventional metronome sound
ELECTRONIC Electronic metronome sound
VOICE ENG. Human voice (English)
VOICE JPN. Human voice (Japanese)
To return to the basic screen, press the [Function] button
or the [Display/Exit] button.
➔ This setting remains stored in memory even while power is
turned off.
Setting the Beat
This setting determines the beat to be used when recording
performance songs.
Numerator 1 or higher (denominator x 2-1)
Denominator 2, 4, 8, 16
1. Press the [Function] button.
2. Using the Select [-] and [+] buttons, select
“Beat.”
fig.09-05
3. Press the [Bwd]/[Fwd] buttons to set the
numeric value for the numerator.
4. To set the denominator, press the [Rec] button
to move the cursor from the numerator to the
denominator.
Press the [Rec] button again if you wish to return to the
numerator.
5. Press the [Bwd]/[Fwd] buttons to set the
numeric value for the denominator.
To return to the basic screen, press the [Function] button
or the [Display/Exit] button.
* When recording your performance with playing Rhythm perfor-
mances or Automatic Accompaniment, the beat is set automati-
cally.
* You cannot change the beat of previously recorded songs.
AT-20S.e.book 80 ページ ２００３年１１月１０日 月曜日 午後２時３７分