Ricoh 3045 - Manual (Page 16)

Getting Started
10
1
Connecting the Machine
Reference
For information about connection
using Ethernet and wireless LAN,
see “Confirming the Connection”,
Network Guide.
For information about connection
using Bluetooth, see the manual
that comes with the optional Blue-
tooth interface unit.
Requirements
Before using this machine, make sure
all environmental and electrical re-
quirements are met. Connect the ma-
chine to the host computer using the
parallel cable, network interface unit,
or both.
Make sure all cables, connectors, and
electrical outlets necessary to attach
the machine to the host computer or
network are at hand.
Connecting the Machine to the
Host Using a USB Cable
You can connect the machine to the
host computer using a USB interface
cable.
This machine does not come with a
USB interface cable. Make sure you
purchase the appropriate cable for the
machine and your computer.
Follow the procedure to connect the
machine to the host computer using a
USB interface cable.
A
Connect the USB 2.0 interface ca-
ble to the USB port.
B
Connect the other end to the USB
port on the host computer.
Note
❒ The USB 2.0 interface board is
supported by Windows 98 SE /
Me / 2000 / XP, Windows Server
2003, Mac OS X v10.3.3 or higher.
• For Windows 98 SE / Me:
Make sure to install “USB
Printing Support”. If USB 2.0
is used with Windows 98 SE
/ Me, only a speed equal to
that of USB 1.1 is possible.
• For Mac OS:
To use Macintosh, the ma-
chine must be equipped with
the optional PostScript 3
unit. If USB 2.0 is used with
Mac OS X v10.3.3 or higher, a
transfer speed of USB 2.0 is
supported.
AJL003S
AdonisC4EN-Printer-F1_FM_forPaper.book Page 10 Friday, May 13, 2005 6:00 PM