Ricoh Aficio 3235C - Manual (Page 152)

Troubleshooting
140
5
Auto Colour Calibration
If a certain colour is strong or the col-
our of the copy differs from the origi-
nal, adjust the yellow, magenta, cyan
and black balance.
Note
❒ If "DToner is almost empty." is
shown on the display panel, the
test pattern cannot be printed.
AAAA
Press the {{{{User Tools/Counter}}}} key.
BBBB
Press [Maintenance].
CCCC
Press [Auto Colour Registration].
DDDD
Press [Start] on the “Copier Func-
tion”.
Note
❒ When performing the auto col-
our calibration from the copy
function, press [Start] under
Copier Function. When per-
forming from the printer func-
tion, press [Start] under Printer
Function.
EEEE
Press [Start Printing] and a test pat-
tern will be printed.
Note
❒ When performing the auto col-
our calibration from the printer
function, select test patterns
from [600 x 600 dpi], [1800
ЧЧЧЧ600
dpi] and [1200 x 1200 dpi] and
then press [Start Printing].
❒ The test pattern will be printed
on an A4
K, 8 1 /
2
”
× 11”K size
page (If A4
K is not available
then A3
L, B4 JISL will be
used.). Make sure to check the
paper set in the paper tray.
❒ The counter will not proceed
when the test pattern is printed.
FFFF
Place the test pattern on the expo-
sure glass and press [Start Scan-
ning]
.
The image will be corrected after
"
Please wait. " disappears.
Note
❒ The test pattern will not be read
if it is set in the ADF.
❒ Set the test pattern in the follow-
ing way:
❒ When the ADF is installed, make
sure to set the test pattern on the
exposure glass, and then 2 or 3
white sheets, same size as the
test pattern, above the test pat-
tern.
ZFLS110E
GCCLCPIE
JupiterC2_GSG_GB_F2_Pre_FM.book Page 140 Thursday, June 2, 2005 1:57 PM