Ricoh Aficio 3235C - Manual (Page 155)

143
6. Remarks
Dos and Don'ts
R WARNING:
R CAUTION:
Important
❒ Do not turn the power off while
the On indicator is lit or blinking.
Doing so may damage the hard
disk.
❒ Before unplugging the power cord
or turning off the main power
switc h, m ake sure remaining
m e m ory space is at 100% , a s
shown on the display. See p.27
“Turning Off the Power” and p.27
“Turning Off the Main Power”.
• When you use this machine for a
long time in a confined space with-
out good ventilation, you may de-
tect an odd smell. To keep the
workplace comfortable, we recom-
mend that you keep it well venti-
lated.
• Do not touch areas on or around
the fusing unit. These areas may
become hot.
• After scanning originals continu-
ously, the exposure glass may be-
c o m e w a r m — t h i s i s n o t a
malfunction.
• The area around the ventilation
hole might feel warm. This is
caused by exhaust air and is not a
malfunction.
• When the machine is not in use
and in stand-by mode, you may
hear a small noise inside. This is
caused by the image stabilization
process and is not a malfunction.
• Do not turn off the power when
the machine is in operation.
• The machine might not produce
good copy images if condensation
forms inside as a result of rapid
temperature change.
• Do not open the covers of the ma-
chine when it is in operation. If you
do, misfeeds might occur.
• Do not move the machine when
the power is on.
• The machine might not produce
good copy images if condensation
forms inside as a result of rapid
temperature change. To avoid pos-
sible condensation, this machine is
equipped with anti-condensation
heaters. Even when the main pow-
er switch is off, the machine con-
t i n u e s t o m a i n t a i n a s t a b l e
temperature when the anti-con-
densation heaters are on.
• If you operate the machine im-
properly or a machine failure oc-
curs, settings might be lost. Be sure
to make a note of your machine
settings.
• The supplier shall not be liable for
any loss or damage resulting from
mechanical failure, loss of settings,
or use of the machine.
• Keep the machine away from
flammable liquids, gases, and
aerosols. A fire or an electric
shock might occur.
• Unplug the power cord from the
wall outlet before you move the
machine. While moving the ma-
chine, you should take care that
the power cord will not be dam-
aged under the machine.
JupiterC2_GSG_GB_F2_Pre_FM.book Page 143 Thursday, June 2, 2005 1:57 PM