Ricoh Network Data Protection Unit Type C - Manual (Page 33)

Setting Up
33
Loading Paper
The following describes how to load paper into the standard paper tray (Tray 1).
❒ To avoid paper jams, make sure paper is not stacked above the limit mark in-
side the tray. Misfeeds might occur.
❒ Do not mix different types of paper in a single paper tray.
A
Pull the paper tray out of the printer until it stops. Lift it slightly, and then
pull it fully out. Place the paper tray on a flat surface.
❒ You cannot pull out Tray 1 if the Bypass Tray is open.
• When pulling the paper tray out, be careful not to pull it strongly. If you do,
the tray might fall and cause personal injury.