Ricoh Network Data Protection Unit Type C - Manual (Page 77)

Installing Options
77
H
Holding the antenna cap with the two cut off corners toward the printer
front cover, fit the cap over the card.
❒ After finishing installation, check the 802.11b interface unit is installed
properly: print the configuration page from the “List/Test Print” menu. If it is
installed properly, you will see “IEEE 802.11b” for “Controller Option”.
❒ If the 802.11b interface unit is not installed properly, reinstall it from the
start of the procedure. If you cannot install it properly even after attempting
reinstallation, contact your sales or service representative.
For details about printing the configuration page, see p.40 “Test Printing” .