Ricoh AFICIO CL3000DN - Manual (Page 17)

Memory Unit Type C (SDRAM Module)
13
1
Memory Unit Type C (SDRAM Module)
R CAUTION:
Important
❒ Before touching the Memory Unit,
touch something metal to dis-
charge any static electricity. Static
electricity can damage the Memo-
ry Unit.
❒ Do not subject the Memory Unit to
physical shocks.
AAAA
Turn off the power, and then un-
plug the power cable.
BBBB
Remove the two screws that fas-
ten the controller board on the
back of the printer.
The removed screws will be used
in step
G to fasten the controller
board.
CCCC
While holding the handle, pull
out the controller board slowly.
There are two slots for the Memory
Unit. Use the available slot (the
one in the front in the illustration
B) to install an optional Memory
Unit
Important
❒ In order to install the maximum
384 MB memory, remove the
standard Memory Unit
A, and
then replace with the 128 MB
Memory Unit. Then install the
256 MB Memory Unit onto the
other slot (the one in the front in
the illustration
B).
❒ When using only one Memory
Unit, be sure to use the slot in
the back shown in the illustra-
tion
A.
• Do not touch the inside of the
controller board compartment. It
may cause a machine malfunc-
tion or a burn.
ZHBP080E
ZHBP020E
ZHBP100E
AresPGBOptionSetup-F_FM.book Page 13 Monday, July 29, 2002 1:12 PM