Ricoh AFICIO CL3000DN - Manual (Page 31)

802.11b Interface Unit Type A
27
1
IIII
Insert the card slowly into the
802.11b Interface Unit with the la-
bel facing down and the uneven
black antenna surface facing up
until it stops.
JJJJ
Align the controller board to the
top and bottom rails, and then
push in slowly until it stops.
Note
❒ When installing other options
on the controller board, do not
close the controller board, but
go to the steps for installing the
option.
Important
❒ The printer may not work prop-
erly if the controller board is not
set properly.
KKKK
Fasten the controller board to the
printer with the two screws that
you removed in step
CCCC .
Note
❒ After finishing installation, you
can check whether the 802.11b
Interface Unit is installed prop-
erly. Print the configuration
page from the "List/Test Print"
menu. If it is installed properly,
you will see "IEEE 802.11b" for
"Controller Option".
❒ If the 802.11b Interface Unit is
not installed properly, reinstall
it from step
B . If you cannot in-
stall it properly even after at-
tempting reinstallation, contact
your sales or service representa-
tive.
Reference
See "Making Printer Settings
with the Control Panel" in the
Administrator Reference for
printing the configuration page.
ZHBP210E
ZHBP220E
ZHBPB230E
AresPGBOptionSetup-F_FM.book Page 27 Monday, July 29, 2002 1:12 PM