Ricoh AFICIO CL3000DN - Manual (Page 41)

Network Interface Board Type 3000
37
1
you removed in step CCCC .
Note
❒ After finishing installation, you
can check whether the Network
Interface Board is installed
properly. Print the configura-
tion page from the "List/Test
Print" menu. If it is installed
properly, you will see "Option
Ethernet Board" for "Controller
Option".
❒ If the Network Interface Board
is not installed properly, rein-
stall it from step
B . If you cannot
install it properly even after at-
tempting reinstallation, contact
your sales or service representa-
tive.
Reference
See "Making Printer Settings
with the Control Panel" in the
Administrator Reference for
printing the configuration page.
Connecting the Network
Interface Cable to the Network
AAAA
Turn off the power
BBBB
Loop the network interface cable
and attach the ferrite core.
Note
❒ Attach two ferrite cores to the net-
work interface cable. One of them
must be attached close to the end
of the cable (on the end closet to
the printer). The other must be at-
tached approximately 45 cm (18")
(
A) apart from the end. Attach
each ferrite core with a loop.
CCCC
Attach the network interface ca-
ble to the jack on the Network In-
terface Unit.
DDDD
Connect the other end of the net-
work interface cable to the network.
EEEE
Turn on the power.
ZHBPA010E
ZHBP913E
ZHBP1470E
AresPGBOptionSetup-F_FM.book Page 37 Monday, July 29, 2002 1:12 PM