Roland SI-24 - Manual (Page 30)

30
Making system settings
Outputting the RPC-1’s R-Bus Out 7/8 from the SI-24
With the factory settings, the RPC-1’s “R-Bus Out 7/8” will not be output from the
SI-24. If you want “R-Bus Out 7/8” to be output from the SI-24, change the setting as
follows.
1. Hold down [SYSTEM] and press [7] (7/8>D.OUT) to turn it on (lit).
If [7] (7/8>D.OUT) is on (lit):
RPC-1 “R-Bus Out 7/8” will be output from DIGITAL OUT.
If [7] (7/8>D.OUT) is off (dark):
RPC-1 “R-Bus Out 1/2” will be output from DIGITAL OUT.
2. To change the setting back, once again hold down [SYSTEM] and press
[7] (7/8>D.OUT).
[7] (7/8>D.OUT) will turn off (go dark).
The RPC-1’s “R-Bus Out 1–8” correspond to the SI-24’s OUTPUT as follows.
RPC-1
SI-24 OUTPUT
[7] (7/8>D.OUT): off (dark) [7] (7/8>D.OUT): on (lit)
R-Bus Out 1 MASTER-L, DIGITAL OUT (L) MASTER-L
R-Bus Out 2 MASTER-R, DIGITAL OUT (R) MASTER-R
R-Bus Out 3 AUX1-L AUX1-L
R-Bus Out 4 AUX1-R AUX1-R
R-Bus Out 5 AUX2-L AUX2-L
R-Bus Out 6 AUX2-R AUX2-R
R-Bus Out 7 – DIGITAL OUT (L)
R-Bus Out 8 – DIGITAL OUT (R)