Roland SI-24 - Manual (Page 34)

34
Controlling Logic RPC Pro
Controlling the equalizer
The buttons and knobs of the SI-24 correspond to the Logic RPC Pro equalizer
parameters as follows.
fig.4-01
PAN knobs 1–8 will operate the equalizer (EQ GAIN 1–4, EQ FREQ 1–4).
Knob 1 ➔ EQ1 GAIN
Knob 2 ➔ EQ1 FREQ
Knob 3 ➔ EQ2 GAIN
Knob 4 ➔ EQ2 FREQ
Knob 5 ➔ EQ3 GAIN
Knob 6 ➔ EQ3 FREQ
Knob 7 ➔ EQ4 GAIN
Knob 8 ➔ EQ4 FREQ
Use the following procedure to operate the equalizer.
1. Press [EQ/SEND] to turn it on (lit).
2. As described in “Selecting channels” (p. 32), select the channel that you want to
control.
The [CHANNEL SELECT] of the selected channel will light.
3. Press EQ [ON] for the equalizer you want to operate, to turn it on/off.
When the equalizer is on, EQ [ON] will light.
4. Use knobs 1–8 to adjust the equalizer “GAIN” and “FREQ.”
dB (GAIN)
Logic RPC PRO
Hz
dB
(FREQ)
(GAIN)
ON
Hz
dB
(FREQ)
(GAIN)
ON
Hz
dB
(FREQ)
(GAIN)
ON
Hz (FREQ)
ON
EQ3
EQ4
EQ2
EQ1
EQ4 EQ1 EQ3 EQ2
In order to control equalizer
parameters from the SI-24, you
must first make settings EQ
Type in Logic RPC Pro.
For details on the procedure,
refer to the Logic RPC Pro
owner’s manual.