Roland SI-24 - Manual (Page 38)

38
Controlling Pro Tools (version 4.1 or later)
Digidesign Pro Tools can be remotely controlled from the SI-24.
■ Putting Pro Tools mode labels
When controlling Pro Tools, the button and knob functions will differ in some ways
from the panel. You will find it convenient to affix the included Pro Tools mode
labels when using the SI-24 with Pro Tools (see figure).
Notes concerning the control of Pro Tools
● The SI-24 is not able to exchange audio with Pro Tools TDM or Pro Tools LE.
● When the protocol (p. 25) is Pro Tools mode, the following buttons and knobs
cannot be used.
• Faders 9–12
• Master fader
• [STATUS 9]
• [STATUS 10]
• CH ASSIGN [INPUT]
• Joystick
• SURROUND PAN [ON]
Making the SI-24 settings
Use the following procedure to switch the settings of the SI-24.
1. Hold down [SYSTEM] and press [2] (H).
[2] (H) will light, and Pro Tools mode will be selected.
2. If you want to use the MIDI connectors (and not R-BUS) to exchange data
between the SI-24 and your computer, hold down [SYSTEM] and press
[6] (MIDI ctrl) to turn it on (lit).
For details, refer to “Using the MIDI connectors to transmit/receive control data—
MIDI Control Mode” (p. 29).
The SI-24 supports Pro Tools software version 4.1 or later.
Before putting Pro Tools mode
labels on top panel of SI-24,
please wipe dust or dirt
adheres with a soft dry cloth.
For details on modes
(protocols), refer to “Selecting
the protocol” (p. 25).