Roland VS-2480 - Manual (Page 168)

11—Input and Track Channel Tools
168 www.rolandus.com Roland VS-2480 Owner’s Manual
At the bottom of the Parameter View screen is a set of four tabbed layers that contain an
F button for each of the viewable parameters or parameter groups for the current
channel. Press the desired F button. To reveal an F button that’s currently hidden, tap
PAGE until the tabbed layer it’s on appears. There are also F buttons for the DYN and
EQ screens that show all their parameters at once, as described below.
At the left side of the screen, you’ll see the displayed parameter’s name. If a group of
related parameters is in view, each is labeled at the left side of the screen.
The Parameter View screen can’t always show all of the channels’ settings for a
parameter at the same time. When all of the channels won’t fit on the screen at once,
you’ll see an arrow pointing to the right at the right-hand side of the screen. You can
press
or click the arrow with your mouse to view the remaining channels, or to go
back.
In some cases, you’ll see up and down arrows at the left edge of the screen. In general,
these mean that there’s more to see above and/or below the current view—you can
press
or , or click either arrow with your mouse. What happens when you click one
of the arrows depends on what’s being viewed.
To return to the normal CH EDIT display, press F6 (CH.V).
The F2 (Surrnd) button is active only when the UTILITY menu’s SURROUND MIX Sw
parameter (Page 321) is turned on.
When the PRM.V screen shows: Use the up and/or down arrows to view:
DYN parameters the DYN screen’s expander/expander+compressor
parameters, and all of the compressor parameters.
See Page 157. At the top of the PRM.V section of the
display, you’ll see the name of the currently displayed
set of dynamics parameters. When the dynamics
processor is set to compressor, all expander-related
parameters are hidden, and vice versa.
EQ parameters all of the EQ screen’s parameters. See Page 162.
FXIns parameters the effect insert settings—and patch name—for each
of the available effects, one at a time. See Page 216. At
the top of the PRM.V section of the display, you’ll see
the name of the currently displayed effect.
AUXSnd parameters the Aux send settings for each of the eight Aux
busses, one at a time. See Page 152. At the top of the
PRM.V section of the display, you’ll see the name of
the currently displayed Aux send.
If you edit a parameter while in Parameter View, its channel automatically becomes the
currently selected channel.
VS2480OMUS.book 168 ページ ２００６年２月７日 火曜日 午後４時１６分