Roland VS-2480 User Manual
Page 351
27—Mastering and CD-R/RW Operations
Roland VS-2480 Owner’s Manual
www.rolandus.com
351
3.
Press CD-RW/MASTERING.
4.
Press F2 (CDWrit)—”Store Current?” appears on the display.
5.
Press ENTER/YES to store the most recent changes to your
project—including any mastering tracks you’ve just created—or
press EXIT/NO to proceed without re-saving your project.
After your press the desired button, the VS-2480 performs a few
setup operations—this takes a few moments. When the VS-2480 has finished
setting itself up for CD burning, the CD-R WRITE screen appears.
If you’ve got a CD-RW disc in your burner, the VS-2480 displays a reminder that
that many CD players can’t play an audio CD-RW:
CD-RW (ReWritable)!!
Can’t be Played back
with Audio CD Player.
Are You Sure?
6.
Press ENTER/YES to proceed, or EXIT/NO to cancel the operation.
7.
If you’re re-using a CD-RW disk that you want to erase, see Page 352.
8.
Make sure you have enough room on the CD for your audio, calculating the space
you’ll need as described in “Making Sure You Have Enough Space” on Page 350.
9.
If your mastering tracks were recorded using a recording mode other than CDR,
verify that you have enough free space on your internal hard drive to create a disk
image file—again, see Page 350.
10. Select the mastering tracks—or other pair of tracks—
you want to burn on the CD. You can select these in
either of two ways. To select your tracks:
•
at the same time
—select the L-Ch SOURCE TRACK
parameter and turn the TIME/VALUE dial to
select the same-numbered V-Tracks on any odd/
even pair of project tracks.
•
individually
—select a pair of V-Tracks using the
L-Ch SOURCE TRACK parameter, and then use
the R-Ch SOURCE TRACK parameter to select a
different right-side V-Track.
If you lack the required space on the CD—or on your hard drive, as in Step 8—press F6
(CANCEL). If the CD is blank and still won’t hold your audio, you’ll need to trim the
audio so that it fits. If the CD has other selections on it already, consider starting a new
CD. If you need to make a disk image and don’t have enough room on your hard drive,
you’ll need to clear some space on the drive before proceeding.
F2 (CDWrit)
Project
info
Drive info
Disk info
You can easily spot a
V-Track recorded in CDR
mode—it has an asterisk in
its number instead of a
hyphen.
CDR-recorded V-Tracks
Standard V-Tracks
VS2480OMUS.book 351 ページ ２００６年２月７日 火曜日 午後４時１６分