Roland VS-2480 - Manual (Page 387)

Roland VS-2480 Owner’s Manual www.rolandus.com 387
Supplemental Information
R-BUS Remote Control
You can remotely control a variety of connected R-BUS devices right from the VS-2480.
To learn how to activate remote control of an R-BUS device, see Page 377. The following
sections describe the parameters in each device that you can set from the VS-2480.
To leave any of the remote control screens described in these sections—and return to
the VS-2480’s R-BUS CONFIG screen—press F6 (EXIT).
DIF-AT Settings
INPUT CH STATUS 1-8
You can set the status of each track on the connected recorder connected to the DIF-AT.
You can choose:
• PLY —to set the track so that it plays back any audio recorded on the track.
• REC —to arm the track for recording.
INPUT SELECT
INPUT SELECT chooses the desired type of digital recorder. You can select:
• ADAT —to use the DIF-AT with an ADAT-format recorder.
• TDIF —to use the DIF-AT with a T-DIF-format recorder.
The parameters discussed in the following sections appear on the VS-2480’s R-BUS
screen only when remote control of the respective device has been activated, as
described on Page 377.
When you’ve connected an RPC-1 card to one of the VS-2480’s R-BUS jack, disable
remote control of that R-BUS jack.
VS2480OMUS.book 387 ページ ２００６年２月７日 火曜日 午後４時１６分