Ricoh 3506 - Manual (Page 168)

Others
156
7
Use and Storage of Supplies
Copy Paper
• Copy paper of the types or in the conditions listed below are not recommend-
ed for this copier.
• Folded, curled, creased, or damaged paper
• Torn paper
• Perforated paper
• Paper with conductive or low electrical resistance coating such as carbon
or silver coating
• Thermal paper, art paper
• Thin paper that has low stiffness
• Damp paper
• Wavy paper
• Stapled paper
• Translucent paper
• Do not use ink-jet printer paper because it may cause serious damage to the
machine.
• Use a recommended OHP transparency and set it in correct direction to pre-
vent failure.
• Fan copy paper and OHP transparencies to get air between the sheets before
loading.
• Do not touch copy paper if your fingers are wet or oily; finger prints may ap-
pear on the copy.
• Load paper with the copy side down in the paper trays. If copies are curled,
try turning the copy paper over in the tray. If there is no improvement,
change to copy paper with less curl.
• When copying on rough surface paper, the copy image may be light.
• When making two-sided copies, do not load paper in the paper tray to copy
the reverse side. Use the bypass tray.
⇒ P.42 “Copying from the Bypass Tray”.