Oki FAX 5250 - Manual (Page 92)

92 OKIFAX 5250
|
8 Press the Yes
ᮤ key. The display shows
BROADCAST/MEMORY TX
9 Press the Yes
ᮤ key.
The display shows
BROADCAST/MEMORY TX.
Press the Yes
ᮤ key.
10 Select a location. Refer to the instructions below.
• To select a One Touch key, press the One Touch key.
• To select an Auto Dial number, press the Auto Dial key,
then enter the two-digit Auto Dial number on the
numeric keypad.
• To select a number dialed on the numeric keypad, dial
as you would on a normal telephone.
• To select a group, use the numeric keypad and press the
# key. Then, enter the number of the group you want to
use.
11 Press the Yes
ᮤ key to confirm your selection. The
display shows
SELECT LOCATION(S).
12 To continue selecting locations, repeat Steps 11 and 12 as
often as necessary.
13 When you are finished selecting locations, press the No
ᮣ key [when the SELECT LOCATION(S) message is
displayed].
14 If you have selected multiple locations, the unit will ask
you if you want to confirm your selections with a printed
report before proceeding.
• If you do, press the Yes
ᮤ key. After the report is
printed, the display shows BEGIN SCANNING?
• If you want to make corrections, press the No
ᮣ key
and go back to Step 9.
• To remove a location, select the location in the same
way, but press the No
ᮣ key to delete it from your
transmission.
15 When all of your selections are correct, press the Start
key. The fax machine scans the documents into memory
and waits until the time and date you have set before
sending the fax. When scanning is completed, the unit is
available for other transmission operations.