Omron ZS-MDC - Manual (Page 30)

2-6
Sect
io
n 2
INSTA
L
LATION &
CONN
ECTION
ZS-MDC
User’s Manual
Section 2
Multi-Controller
3.
Open the connector cover on the con-
troller.
Slide the cover to remove.
4.
Insert the Controller Link Unit into the
connector on the Multi-Controller.
The connectors are designed to be connected in a
particular direction. Insert the connector in the direc-
tion so that the indented section of the Controller
Link Unit in the figure on the right matches the con-
nector protrusion on the Data Storage Unit.
5.
Slide the Sensor Controller to insert to
the Controller Link Unit connector.
●
Removal procedure
The following describes how to remove the Multi-Controller and Sensor Controller from
the DIN track.
1.
Slide and remove the Sensor Controller
from the connector on the Controller
Link Unit.
2.
Slide the Controller Link Unit and
remove from the connector on the Multi-
Controller.
3.
Install the cover on the coupler of the controller.
H LD O N ZER O ENABLE P
L
H LD O N ZER O ENABLE P
L
H LD ON
ZERO
ENABLE P
L
H LD ON
ZERO
ENABLE P
L
Controller
Link Unit (sold
separately)
Indented
section
H LD O N ZER O ENA BLE
P
L
H LD O N ZER O ENA BLE
P
L
H LD O N ZER O ENA BLE
P
L
H LD O N ZER O ENA BLE
P
L
Controller
Link Unit
(sold sepa-
rately)