Omron ZS-MDC - Manual (Page 58)

4-2
Sect
ion 4
APPLICATION SETTING EX
AMPLE
S
ZS-MDC
User’s Manual
Section 4
Measuring the Thickness of Multiple Points (sandwiched thickness)
Measuring the Thickness of Multiple Points (sandwiched thickness)
This is an example of how to measure the sandwiched thickness at three places on a
workpiece, and calculate the difference (max. value - min. value) of each measured
thickness value. [THICK] and [MAX-MIN] are used as the operation modes.
For details on how to connect and install the Sensor Heads and Sensor Controllers, refer to the “ZS-L
User’s Manual”.
FUN Mode-[SENSING]-[SEL CH]
1.
Assign the CH No. of the controller to inputs
A to F to be used for the expression.
INPUT A:1CH
INPUT B:2CH
INPUT C:3CH
INPUT D:4CH
INPUT E:5CH
INPUT F:6CH
Thickness
Input A Input C
Input B Input D
Input E
Input F
Input A Input B Input C Input D Input E Input F
CH0 CH1 CH2 CH3 CH4 CH5 CH6
The operation and/or measurement results are output
as judgement output or linear output.
▲
1 INPUT A
3 INPUT C
2 INPUT B