Olympus DM 620 - Manual (Page 41)

41
3
EN
Pla
yback
Playback
About music file
In cases where the recorder is unable
to playback music files that have been
transferred to it, check to make sure that the
sampling rate and bit rate are in the range
where playback is possible. Combinations of
sampling rates and bit rates for music files
which the recorder can playback are given
below.
File format
Sampling
frequency
Bit rate
WAV format 44.1 kHz, 48 kHz 16 bit
MP3 format
MPEG1 Layer3:
32 kHz, 44.1 kHz,
48 kHz
MPEG2 Layer3:
16 kHz, 22.05 kHz,
24 kHz
From 8 kbps
up to 320
kbps
WMA format
8 kHz, 11 kHz,
16 kHz, 22 kHz,
32 kHz, 44.1 kHz,
48 kHz
From 5 kbps
up to 320
kbps
• Variable bitrate MP3 files (in which
conversion bitrates can vary) may not be
played back properly.
• For WAV files, this recorder can only
play back those in the linear PCM format.
WAV files other than these cannot be
played back.
• Even if the format of the file is compatible
for playback on this recorder, the recorder
does not support every encoder.
Locating the beginning of a file
While the recorder is during stop
mode or playback mode, press the
9 button.
• The recorder skips to the beginning of
the next file.
While the recorder is during
playback mode, press the
0
button.
• The recorder skips to the beginning of
the current file.
While the recorder is during stop
mode, press the
0 button.
• The recorder skips to the beginning of
the previous file. If the recorder is in
the middle of a file, it will return to the
beginning of the file.
While the recorder is during
playback mode, press the
0
button twice.
• The recorder skips to the beginning of
the previous file.
Notes
• When you skip to the beginning of the
file during playback, the recorder will
stop at the position of the index mark
or temp mark. The index mark and temp
mark will be skipped when you perform
the operation in stop mode (
☞ P.45).
• When [Skip Space] is set to other than
[File Skip], the recorder will skip forward/
reverse the specified time, then will start
playback (
☞ P.61).