Onkyo DR-S2.2 - Manual (Page 17)

17
Connecting to a TV (European model)
Before connecting
• Refer also to the instruction manual of the TV.
• When you connect the DVD Receiver to the TV, be sure to turn
off the power and unplug both the units from the mains before
making any connections.
• Connect the DVD Receiver to the TV directly. If you connect the
DVD Receiver to a VCR, TV/VCR combination, or video selector,
the playback picture may be distorted as DVD videos are copy
protected.
• Connect the plugs securely.
Incomplete
Insert completely
REMOTE
CONTROL
OUT
2 ––VIDEO –– 1 VIDEO 2 VIDEO 1
IN IN IN IN OUT OUT
IN OUT IN IN IN
VIDEO2
CDR/PC
VIDEO 1 TAPE
MD/HD
TV/LINE
MON
OUT
MON
OUT
L
R
VIDEO
S VIDEO
AUDIO
SUB
WOOFER
PRE OUT
SURROUND
SPEAKERS
AUDIO
R L
FRONT SPEAKERS CENTER
SPEAKER R L
FM
75
ANTENNA DIGITAL
OUTPUT
DIGITAL INPUT
VIDEO 2 VIDEO 1
OPT OPT COAX
AM
AV CONNECTOR
S VIDEO
IN
VIDEO
IN
AUDIO
OUT
R
L
AC
CONNECTOR
■ Connecting to a TV Using the SCART Cable
Connect the DVD Receiver and your TV using the supplied SCART cable.
If the TV is compatible with S video signals
After completing the steps on page 26, set “Video Out” to “S Video” using the menu
explained in “Customizing the Function Settings” starting from page 64. See page 67 for
direct information.
If an RGB monitor is connected to the DVD Receiver
After completing the steps on page 26, set “Video Out” to “RGB” using the menu explained
in “Customizing the Function Settings” starting from page 64. See page 67 for direct
information.
■ Connecting to a TV usinf the Audio/Video
connection cable or S video connection
cable
If the TV or monitor does not has an AV CONNECTOR
input terminal, make video connection using audio/video
connection cable.
If your TV has an S video input jack, make the S video
connection. The S video connection will provide higher
quality picture playback. Be sure not to disconnect VIDEO
MON OUT.
DO NOT connect the
power cord (mains lead)
at this time.
TV or projector
SCART cable
To AC CONNECTOR
input terminal
TV or projector
Be sure to set the digital output setting after connection using the
Setup Navigator explained in “Setting Up the DVD Receiver” starting
on page 27 or the function setting menu explained in “Customizing
the Function Settings” starting on page 64.
L (White)
R (Red)
Video
(Yellow)
S video connection cable
Audio/video
connection cable
Signal flow
See “Turning the unit on/off with the TV’s power
switch — IPM function” on page 22 for Inteligent
Power Management (IPM) function.