Onkyo DR-S2.2 - Manual (Page 47)

47
T-D SETUP
UP/DOWN 5/∞
Press MODE AUDIO first.
→
Activating Theater-Dimensional mode
See “The Input Sources and Available Listening Modes” on
page 45.
1
2
Adjusting Theater-Dimensional mode
Press T-D.
“Theater-Dimensional” scrolls across in
the display and the Theater-Dimensional
indicator on the unit lights.
Unit
Remote controller Activate Theater-Dimensional (see
the steps in the left column of this
page).
Press T-D SETUP repeatedly to
select the Theater-Dimensional
item (see on the previous page).
Each press of the button changes the item
as follows:
Lisng. Angle
↓
V. Surr Level
↓
Dialog Mode
↓
The normal display resumes.
Press UP/DOWN 5/∞ to select the
setting of the item.
• To change the setting of another item,
repeat steps 2 and 3.
• To end the Theater-Dimensional setup,
press T-D SETUP repeatedly until the
normal display resumes.
T-D
(Indicator and button)
Remote controller
only
3
Notes
• Theater-Dimensional mode cannot be activated if;
– Headphones are connected,
– SPEAKERS B system is On (North American and South American
models only), or
– The source is PCM sound with a sampling frequency higher than
48kHz.
• Theater-Dimensional mode will be canceled and the T-D indicator
goes off when:
– Another listening mode is chosen, or
– The input source is switched to a type of source which Theater-
Dimensional mode cannot process.
T-D