Onkyo DR-S2.2 - Manual (Page 33)

33 33
Press TEST TONE.
Each speaker emits the test tone (pink
noise) and the display shows the speaker
emitting the test tone in the following
order:
Left → Center
(Front left ch.) (Center ch.)
↑ ↓
Subwfr Right
(Subwoofer) (Front right ch.)
↑ ↓
Surr L
←
Surr R
(Surround left ch.) (Surround right ch.)
Note
No test tone will be emitted from the speaker
which is not included in the speaker
configuration on pages 29-31 even if it is
actually connected.
Press CH SEL repeatedly to select
the speaker, then press UP/DOWN
5/∞ to adjust the volume level.
The volume level can be adjusted between
–12dB and +12dB.
2
Adjusting Each Speaker's Relative Volume Balance – Test Tone
Adjust each speaker’s relative volume balance so that the
volumes of all speakers’ test tones sound equal at the
listening position.
When you have completed the
adjustment by repeating step 2,
press TEST TONE.
The test tone stops and the normal display
resumes.
Note
Even if you don’t press TEST TONE, the test
tone will stop after two minutes.
1
Remote controller
only
3
«
CH SEL
TEST TONE
UP/DOWN 5/∞