Oki MC160n - Manual (Page 161)

161 Replacing Consumables
Replacing All Toner Cartridges at the Same Time
Note
Be careful not to spill toner while replacing a toner cartridge. If toner spills,
immediately wipe it off with a soft, dry cloth.
By selecting the EJECT MODE in the PRINTER MODE menu, all toner car-
tridges can be replaced at the same time.
Follow the procedure described below to use the EJECT MODE.
1
With the main screen displayed, press the key to display the PRINTER
MODE screen.
2
Press the key to select T/C CHANGE and then press the Enter key.
3
Press the key to select EJECT MODE and then press the Enter key.
4
Perform the operations described in steps 6 through 15 of “Replacing a Toner
Cartridge” on page 154 through 7-9 to replace the magenta toner cartridge.
"
To exit EJECT MODE, press the Stop/Reset key.
5
Follow the same procedure to replace the cartridges for the cyan, black, then
yellow toners.
6
Press the Stop/Reset key to reset the machine.
"
The machine must complete a calibration cycle (less than 2 minutes)
after a toner cartridge has been replaced. If you open the scanner unit
or front cover before the machine is reset, the calibration stops, then
starts over again after the cover is closed.