Oki MC160n - Manual (Page 176)

176 Maintenance
Maintaining the Machine
CAUTION!
Read all caution and warning labels carefully, making sure to follow any
instructions contained in them. These labels are located on the inside of
the machine’s covers and the interior of the machine body.
Handle the machine with care to preserve its life. Abuse handling may cause
damage and void your warranty. If dust and paper scraps remain on the inside or
outside of the machine, machine performance and print quality will suffer, so the
machine should be cleaned periodically. Keep the following guidelines in mind.
WARNING!
Turn off the machine, unplug the power cord, and disconnect all interface
cables before cleaning. Do not spill water or detergent into the machine;
otherwise the machine will be damaged and an electric shock may occur.
CAUTION!
The fuser unit is hot. When the top door is opened, the fuser unit
temperature drops gradually (one hour wait time).
„ Be careful when cleaning the inside of the machine or removing media mis-
feeds, as the fuser unit and other internal parts may be very hot.
„ Do not place anything on top of the machine.
„ Use a soft cloth to clean the machine.
„ Never spray cleaning solutions directly on the machine’s surface; the spray
could penetrate through the air vents of the machine and damage the internal
circuits.
„ Avoid using abrasive or corrosive solutions or solutions that contain solvents
(such as alcohol and benzene) to clean the machine.
„ Always test any cleaning solution (such as mild detergent) on a small incon-
spicuous area of your machine to check the solution’s performance.
„ Never use sharp or rough implements, such as wire or plastic cleaning pads.
„ Always close the machine’s covers gently. Never subject the machine to
vibration.
„ Do not cover the machine immediately after using it. Turn it off and wait until it
cools down.