SUUNTO Vector HR - Manual (Page 19)


6. place the new cell into the battery compartment (negative side down, positive side up);
7. ensure that the o-ring is in place to keep the Wristop computer waterproof and place the battery compartment cover back onto the
backside of the Wristop Computer;
8. insert a coin back into the coin slot; and
9. turn the coin clockwise to the close position marked on the back of the case.
note: Battery replacement should be performed with extreme care so as to ensure the Wristop computer continues to remain waterproof.
It is the operator’s responsibility to take due care to ensure that the Wristop computer remains waterproof.
note: after every battery replacement, it is necessary to calibrate the magnetic sensor. details on performing this process are found in
calibrating the compass section of this guide.
1.8 baTTeRy RePlaCeMenT of THe suunTo
TRansMITTeR belT
The transmitter belt operates on a 3-Volt lithium cell, type: CR 2032. The average expected battery life of the transmitter belt is 200
hours of use in ideal operating temperatures. Replace the battery as illustrated here:
Note: Suunto recommends that the battery cover and the O ring are changed simultaneously with the battery to ensure that the
transmitter remains clean and water resistant. replacement covers are available with replacement batteries.