SUUNTO Vector HR - Manual (Page 51)

44
If you have set the compass to track a certain bearing, the segments on the circumference indicate the difference between the direction
in which you want to go and your actual bearing.
7.1.4 Why do the segments on the circumference go to the left
(counterclockwise)?
you are in the difference measurement mode and your unit is showing a decreasing value.
normally, they always go to the right (clockwise) from the -noon position.
In normal mode, the segment display increases clockwise, but if you are in a mode that shows you differences (such as vertical
ascent/descent), all decreasing values go counterclockwise from the center position, and all increasing values go clockwise. so, it is
“minus” to the left (counterclockwise), and “plus” to the right (clockwise).
7.1.5 Why are there two symbols above the Mode texts and what
do they mean?
the left-hand symbol indicates that the altitude alarm is activated and the right-hand symbol indicates that one, two, or three daily
alarms are activated.
7.2 HeaRT RaTe MonIToR
7.2.1 What should I do if there is no heart rate reading?
. check that the elastic strap is snug enough.
. check that the electrodes of the transmitter are moistened and that you are wearing it as instructed.
3. check that you have kept the transmitter clean.
4. check that there are no sources of electromagnetic radiation in the close vicinity of the Wristop computer, such as tv sets, cellular
phones, crt monitors etc.
7.2.2 What is the longest time I can set in the timer?
the maximum range of the countdown timer is 3 hours 59 minutes and 59 seconds for each of the 99 intervals.