SUUNTO Vector HR - Manual (Page 32)

5
5. at the desired day, press the [mode] button to accept the changes and return to the main mode.
note: If the user does not press any button for 1 minute in the setup mode, the display will automatically exit setup.
setting the time is now complete.
3.2 daIly alaRM sub Mode
the Daily alarm sub mode allows the user to select and set up to 3 alarms. the alarm volume cannot be changed.
In the tIme mode, press the [select] button once to enter this sub mode.
In the Daily Alarm mode (Fig. 19):
• field  displays “on” or “off” (the activation status of a particular alarm),
• field  displays the time of a particular alarm, and
• field 3 displays the alarm (, , or 3) the user is viewing.
pressing the [+] or the [-] button will toggle between the alarms , , or 3 to view the settings for each alarm.
3.2.1 How to set the daily alarms
. press the [+] or the [-] button to select the desired alarm to be set (, , or 3).
2. PRESS the [Select] button and hold in for 2 seconds. Located in Field 1, the “ON” or “OFF” will begin to flash.
3. press either the [+] or the [-] button to toggle between “on” and “off”.
4. at the setting desired, press the [select] button to move to the next setting. located in the center of field , the hour will begin
to flash.
5. press the [+] button to scroll the hour upward or press the [-] button to scroll the hour downward.
6. at the hour desired, press the [select] button to move to the next setting. located on the right of field , the minutes will begin
to flash.
7. press the [+] button to scroll the minutes upward or press the [-] button to scroll the minutes downward.
8. at the minutes desired, press the [mode] button to accept the changes and exit the setup program. a small bell will appear at the
bottom left side in field  to signify an alarm has been activated.
the alarm setup is complete. to activate up to three alarms, please repeat steps -8 for the selected alarm (, , or 3).