Omega Speaker Systems High Speed Load Cell Interface Card LCIC-WIM-BEN - Manual (Page 59)

58
RS485 Commands
Except ‘ N x <c/r> ’ (paragraph d), these commands are available
also in the fill mode.
a. Activate address x ( x =1, 2, 3, …, 62, 63, 64):
: x <c/r>
Board(s) response:
1. If address x is already active :
! x <c/r>
(The board reports that it is already active and has nothing to
do.)
2. If address x is not active :
2.1 If another address is currently active:
^ x <c/r> (I’m going to sleep)
(The ‘falling’ board reports that it received an activation
command to another board, then it makes itself inactive.)
2.2 If address
x exists:
A x <c/r> (I’m becoming active)
(The ‘rising’ board reports that it makes itself active.)
(Please refer to the notes on the next page.)