Oracle Audio Technologies Sun StorageTek ATCA 4Gb FC Dual Port HBA SG-XPCIE2FC-ATCA-Z - Manual (Page 16)

10 Sun StorageTek ATCA 4Gb FC Dual Port HBA Installation Guide • April 2010
FIGURE 2-2 Inserting the HBA Into the AMC Connector
4. Carefully plug the HBA into the AMC connector ( FIGURE 2-2 ).
Ensure that the HBA is seated correctly in the connector.
Caution – Do not use excessive force when installing the HBA into the slot. You
might damage the AMC connector on the Netra board, causing permanent damage
to the HBA or board. If the HBA does not seat properly when you apply even
pressure, remove the HBA and carefully reinstall it.
5. If the module handle was pulled out when you inserted the HBA, push the
handle all the way in.
6. If the server is powered on, the HS LED next to the module handle blinks two
or three times.
When the HS LED goes dark, the HBA is installed.
▼ To Connect the Optical Cable
Note – The HBA does not allow normal data transmission on an optical link unless
it is connected to another similar or compatible Fibre Channel (FC) product (that is,
multimode to multimode).
Use multimode fiber-optic cable that is intended for short-wave lasers. The cable
must adhere to the specifications in
TABLE 2-1 .