Quantum Data 882E - Manual (Page 24)

23 882E Quick Start Guide - HDCP Compliance Testing with Encryption Status Tester (EST) - P/N 68-00210 Rev. B
14. Select HDCP to access the HDCP compliance test menu.
The following is displayed on the generator’s LCD.
15. Select !CompRpt to initiate the HDCP compliance test.
The message “HDCP Compliance Test” is shown and then all the tests are shown in
sequence.
Alternatively, you can run the tests using the following command:
CPTX:CPTR 46 // specifies that all applicable tests will be run.
CPTX:CPTU // Initiates the execution of the test
Refer to “ To view the HDCP compliance report: ” on page 42 for procedures on how to
view the generated report.
16. Monitor the 882E LCD for a set of prompts during the 3A-01 and 3A-05 tests.
a. When prompted shown below occurs, power cycle the device under test:
b. Press the button adjacent to the Next! indication after the device under test is back
on to continue.
c. When prompted with the screen shown below, examine the video on the display
under test and press the appropriate button adjacent to the indication (Yes! or No!)
to continue.
Note: The prompt asks you if the video appearing on the connected display looks
good. “Looks good” means that there is a picture and an absence of excessive snow.
17. (Optional) To run a specific test you can use the command line as shown below:
CPTX:CPTR 20 // Selects specific test (e.g. 3A_01) see table below
CPTX:CPTU // Initiates the execution of the test
You can query the complete list of tests to choose from:
CPTX:GCTN? // Queries the list of tests supported
You can query the currently selected test to run with:
!CompRpt EditPCP
Please power cycle
the DUT
Next!
Does the video look
good?
!Yes No!