Quantum Data 882E User Manual
Page 33
32
882E Quick Start Guide - HDCP Compliance Testing with Encryption Status Tester (EST) - P/N 68-00210 Rev. B
XVSI
4
// Activates the HDMI-H interface
ALLU
// Applies the interface setting to the generator
3. Press the
Interface key repeatedly until the following menu appears:
4. Choose the HDMI IN 1 by pressing the adjacent soft key.
5. For the 882E when using the EST, verify that the source is sending in video using the
timing measurement function of the analzyer. Refer to “
Measuring timing of video
signal
” on page 241 of the User Guide for information on running the timing test.
Verify that the source is outputting the 640x480p at 59.94/60Hz format (DMT0660):
If the 882 cannot detect the incoming video enter the following command to turn on the
EST:
QD:PROD:EST
// Turns on the EST.
6. Press the
Tools key and choose the Reports item by pressing the adjacent soft key.
The following is displayed on the generator’s LCD.
7. Select
HDCP to access the HDCP compliance test menu.
The following is displayed on the generator’s LCD.
8. Select
EditPCP to define the capabilities of the HDCP device under.
The following is displayed on the generator’s LCD.
HDMI IN 1
HDMI IN 2
*
EDID
Packets
Misc
HDCP
!CompRpt
EditPCP
Source
:DUT Type
0
1
+Source_Out_OnlyRep
:Source_Authe_Cnt
:Source_Max_KSV