Texas Instruments TMS320C6455 - Manual (Page 15)

REFR
DDR2CLKOUT
DDR2CLKOUT
DCE0
DSDCKE
DSDRAS
DSDWE
DSDDQM[3:0]
DSDCAS
DBA[2:0]
DEA[13:0]
www.ti.com Peripheral Architecture
2.4.2 Refresh Mode
The DDR2 memory controller issues refresh commands to the DDR2 SDRAM device ( Figure 4 ). REFR is
automatically preceded by a DCAB command, ensuring the deactivation of all CE spaces and banks
selected. Following the DCAB command, the DDR2 memory controller begins performing refreshes at a
rate defined by the refresh rate (REFRESH_RATE) bit in the SDRAM refresh control register (SDRFC).
Page information is always invalid before and after a REFR command; thus, a refresh cycle always forces
a page miss. This type of refresh cycle is often called autorefresh. Autorefresh commands may not be
disabled within the DDR2 memory controller. See
Section 2.8 for more details on REFR command
scheduling.
Figure 4. Refresh Command
15 SPRU970G – December 2005 – Revised June 2011 C6455/C6454 DDR2 Memory Controller
Submit Documentation Feedback
Copyright © 2005 – 2011, Texas Instruments Incorporated