Texas Instruments TMS320C6455 - Manual (Page 25)

Command/Data
Scheduler
Command FIFO
Write FIFO
Read FIFO
Registers
Command
to Memory
Write Data
to Memory
Read Data
from
Memory
Command
Data
EDMA BUS
www.ti.com Peripheral Architecture
Figure 15. DDR2 Memory Controller FIFO Block Diagram
2.7.1 Command Ordering and Scheduling, Advanced Concept
The DDR2 memory controller performs command re-ordering and scheduling in an attempt to achieve
efficient transfers with maximum throughput. The goal is to maximize the utilization of the data, address,
and command buses while hiding the overhead of opening and closing DDR2 SDRAM rows. Command
re-ordering takes place within the command FIFO.
The DDR2 memory controller examines all the commands stored in the command FIFO to schedule
commands to the external memory. For each master, the DDR2 memory controller reorders the
commands based on the following rules:
• Selects the oldest command
• A read command is advanced before an older write command if the read is to a different block address
(2048 bytes) and the read priority is equal to or greater than the write priority.
NOTE: Most masters issue commands on a single priority level. Also, the EDMA transfer controller
read and write ports are considered different masters, and thus, the above rule does not
apply.
The second bullet above may be viewed as an exception to the first bullet. This means that for an
individual master, all of its commands will complete from oldest to newest, with the exception that a read
may be advanced ahead of an older, lower or equal priority write. Following this scheduling, each master
may have one command ready for execution.
25 SPRU970G – December 2005 – Revised June 2011 C6455/C6454 DDR2 Memory Controller
Submit Documentation Feedback
Copyright © 2005 – 2011, Texas Instruments Incorporated