Toshiba SL-5300 Series - Manual (Page 100)

15. SET UP MODE EO1-31009
15.2 Label Format Setting
15- 5
Item Procedure
Label length 1. Input a value. (300 – 2000)
2. Touch the Label length area.
NOTE: The unit of the value is 0.1 mm. Refer to the Print coordinate
diagram.
Label width 1. Input a value. (480 – 800)
2. Touch the Label width area.
NOTE: The unit of value is 0.1 mm. Refer to the Print coordinate diagram.
Gap 1. Input a value. (0 – 30)
2. Touch the Gap area.
NOTE: The unit of value is 0.1 mm. Refer to the Print coordinate diagram.
X position fine adjustment 1. Select the adjustment direction by touching the [+] or [-] key.
[+]: Right
[-]: Left
2. Input a value. (0 – 20)
3. Touch Fine adjustment area.
NOTES:
1. The unit of value is 0.1 mm.
2. When the value is 0, the adjustment direction key is fixed to the [+] key.
Print coordinate diagram
Label Width
Label Length
X
Y
Gap
(0, 0)
Feed Direction