Toshiba SL-5300 Series - Manual (Page 20)

8. LOADING/REPLACING THE MEDIA EO1-31009
8. LOADING/REPLACING THE MEDIA
8- 2
Media Roll Stopper
Media Guide
Label Roll Holder
WIDTH
2. Move the media guide and the media roll stopper to the right and place a label roll into the label
roll holder.
NOTES: 1. When the inner part of the label roll is protruding,
flatten it on a level surface.
2. Do not use labels rolled loose, as this may
cause a paper jam. Re-roll the label tightly.
3. Move the media roll stopper to the label edge. Make sure that the label roll stopper’s front part,
where the label “ WIDTH” is attached, is set along with the label edge.
4. Pull the top end of the label past the strip plate so that the labels pass under the pinch roller unit.
Media Roll Stopper
Pinch Roller Unit
Strip Plate