Test-Um VALIDATOR-NT NT955 - Manual (Page 90)

89
Test-Um NT955 Series
Ping Test
1. Select Ping Test.
2. Press Select to begin DHCP request (DHCP box checked)
or to Configure IP addresses in manual address mode (box
unchecked). In manual address mode, be sure the displayed
addresses are appropriate for the network being tested. If not,
use the keypad, Backspace (F1) and Delete (F2) soft keys to edit
My IP Address, Gateway Router (GWRTR) and Domain Name
Server (DNS).
3. To change the targets, press the Targets soft key (F4) to
enter the Manual Ping Targets screen and use the keyboard,
Backspace (F1) and Delete (F2) soft keys to edit the target IP
addresses. When entering addresses, the * button is a shortcut
for the period (.) punctuation mark. Press escape when done to
return to the previous screen.
4. Press the Ping Tool soft key to begin pinging the entries with the
box checked.
5. Press Quit to return to the IP Address screen.
Cisco Delivery Protocol
1. Select Cisco Delivery Protocol.
2. Using the RJ45 port, connect the appropriate cable assembly
from the Validator-NT main unit to one end of the cable or jack
and the remote unit to the opposite end of the cable or jack to be
identified.
3. Press Select to display a message “Reading CDP packets from
network” appears on your screen below the CDP message.
Validator TM Network Tests