Topcom BUTLER 2562 User Manual
Page 33
BUTLER 2562
33
ENGLISH
if your additional handset is a 2500/2505/2510/2550/2560/2561/2562/2600/2605/2610/ 2660/2661/2662/2700/2705/
2710/2750/2760/2761/2762
3. Enter the menu by pressing
/OK
4. Select REGISTRATION using the
and
keys
5. Press OK
6. Enter a base number ( from 1 to 4 ). The flashing numbers are already in use.
7. Enter the Base PIN code (0000 by default )
8. Press OK. The handset will start searching for the DECT base
9. If the handset has located the base, it will display the base identification number, validate the
base registration by pressing OK or stop by pressing ,
10. If the handset does not locate the base, it will return to the standby mode after a few seconds.
Try again by changing the base number and check that you are not in a environment where there
is interference. Move closer to the base.
if your handset is another model
After starting the registration procedure on the base, register the handset (see handset manual to find out how). The
handset must be GAP compatible.
The icon
and the text "NOT REGISTERED" flashes on the display when the handset is not associated with the base.
When a handset is associated with a base, it is attributed a handset number by the base. It is this number that is displayed
on the handset after the name and must be used for internal calls.
7.2 REMOVING A HANDSET
You can remove a handset with a base to allow another handset to be registered
1.
Enter the menu by pressing
/OK
2.
Select setup using the
and
keys
3.
Press OK
4.
Select REMOVE HS using the
and
keys
5.
Press OK
6.
Enter the 4 digit base PIN code
7.
Press OK
8.
Select the handset to be removed
9.
Press OK to validate
HL_B2562_scan.book Page 33 Monday, December 29, 2003 12:15 PM