Teac MCDV600 - Manual (Page 15)

15
A Remote sensor
Receives signals from the remote control unit. Point the remote
control unit at this sensor when operating the remote control
unit.
B Display
C Disc tray
D VOLUME
Turn this knob to adjust the volume level.
E Skip (.//)/PRESET
In FM mode, use these buttons to select a preset channel.
In DISC or USB mode, use these buttons to skip tracks/files.
F Stop ( H)
In DISC or USB mode, use this button to stop playback.
G Play/Pause (G/J)
In DISC or USB mode, use this button to start or pause playback.
H OPEN/CLOSE ( L)
Use this button to open and close the disc tray.
When the tray is opened during playback, it may take a few
seconds before the disc is “unloaded” and the tray opens.
I FUNCTION
Use this button to select a source.
J PROGRAM
In FM mode, use this button to preset stations.
In DISC or USB mode, use this button to program tracks.
K Search (m/,)/TUNING
In FM mode, use these buttons to tune in to a station.
In DISC or USB mode, use these buttons to search for a part of a
track/file.
L REPEAT
In DISC or USB mode, use this button for Repeat or Shuffle
Playback.
M USB connector
You can connect an USB memory device to this connector.
N AUX 2 IN
You can connect a portable audio player to this jack.
O PHONES
To listen with headphones, first lower the volume level to the
minimum. Then, connect the headphones plug into the PHONES
jack, and adjust the volume by turning the VOLUME knob.
The speakers will make no sound when headphones are plugged
in.
CAUTION
Do not connect headphones with the PHONES jack while
wearing them. Moreover, do not disconnect headphones or turn
the unit on or off while wearing them. Very loud sound could be
output from the headphones.
AVOID DAMAGING YOUR HEARING - Do not put on headphones
until after plugging them in.
P STANDBY/ON
Use this button to turn the unit on and standby.
The illumination turns off when the unit is turned on.
The illumination lights orange when the unit is in the standby
mode.