Teac MCDV600 - Manual (Page 43)

43
6
Turn the unit on and prepare the source.
To play a disc, select “DISC Source” using the FUNCTION button
and set a disc.
To play an USB memory device, select “USB Source” using the
FUNCTION button and set an USB memory device.
To listen to the FM, select “FM Radio” using the FUNCTION
button and tune in to a station.
7
Press the STANDBY/ON button to turn the unit off
(standby).
The clock and the TIMER indicator ( ) are displayed.
< The unit will turn on at the specified time every day.
< The unit turns on with the source that was last selected.
Do not forget to turn the unit off (standby), or the timer
will not work.
If the timer reaches the timer-on time, the unit is set to
“SLEEP-60” automatically and the power will be switched off
(standby) 60 minutes later.
If you want to listen continuously, press the SLEEP button
repeatedly to select “SLEEP OFF” after reaches the timer-on-time.
To cancel the Wake Up Timer
In standby mode, press the TIMER button repeatedly until the
“ON” blinks on the display. Then set the Wake Up Timer to “OFF”
by pressing the VOL+ or VOL- button and the TIMER button (the
Wake Up Timer will be cancelled).
Unplugging the unit also cancels the Wake Up Timer.
Troubleshooting(1)
If you have problems with your system, look through this chart and
see if you can solve the problem yourself before calling your dealer or
TEAC service center.
General
No power.
e Check the connection to the AC power supply. Check and make
sure the AC source is not a switched outlet and that, if it is, the
switch is turned on. Make sure there is power to the AC outlet by
plugging another item such as a lamp or fan.
e Press the STANDBY/ON button to turn the unit on.
Remote control does not work.
e Press the STANDBY/ON button to turn the unit on.
e If the batteries are dead, change the batteries.
e Use remote control unit within the range (16 ft/5 m) and point at
the front panel.
e Clear obstacles between the remote control unit and the main
unit.
e If a strong light is near the unit, turn it off.
Severe hum or noise is heard.
e Place the unit as far away from a TV as possible.
e Make sure the line cords and speaker cables are as far away from
the AC supply as possible.
DISC/USB
Will not play.
e Reload the disc with the label side UP.
e Use a playable disc (page 6).
e If the disc is dirty, clean the surface of the disc.
e A blank disc has been loaded. Load a prerecorded disc.
e Check the region code of the DVD (page 6).
e If the unit is condensed, leave the unit for one or two hours with
the power turned on (page 5).
PROHIBIT icon “A” appears on the screen.
e The operation is not permitted by the disc or the unit.
e Note that during playback of a title part (cautions, software
maker’s logo, etc.), most operations are prohibited by the disc.
e If another operation is still in process, wait a moment and try
again.
Cannot access some setup menu items.
e Although it is possible to enter the setup screen while playback
is continuing (or in resume mode), not all menu functions will be
available. Expand the number of available functions by pressing
the Stop (H) button twice.
Scanning stops.
e Scanning does not work within menus.
Sound skips.
e Place the unit on a stable place to avoid vibration and shock.
e If the disc is dirty, clean the surface of the disc.
e Do not use scratched, damaged or warped discs.